Are you looking for the best Arizer Solo 3 v2 cleaning guide? Well, you’re in luck because the Arizer Solo 3 v2 is probably the easiest vaporizer to clean on the market. It’s so easy to clean because it uses all glass “aroma tubes” and minimal residue. So stick around and let me show you how to clean the arizer solo 3 v2!
Let’s dive into the Arizer Solo 3 v2 Cleaning Guide!
Step 1: Gather Your Supplies
You’ll need the following:
- Your Arizer Solo 3 v2
- Your Aroma Tube(s)
- A small brush
- A glass or jar
- Q-tips
- And Isopropyl alcohol (the higher percentage the better)
Step 2: Remove the Aroma Tube
Simply remove your aroma tube from your Arizer Solo 3 v2. Easy peasy lemon squeezy 😉
Step 3: Brush Out Your Aroma Tube
Use your small brush to clean out any left-over herb from your Aroma Tube
Step 4: Soak In Isopropyl Alcohol
Simply pour your ISO into a cup or jar then place your aroma tube into the ISO bath for it to soak for a few minutes. I like to leave mine for about ten minutes or so.
Step 5: Use A Q-Tip
Use a couple of q-tips to clean out your aroma tube.
Step 6: Rinse Aroma Tube in Warm Water
Take your aroma tube, and run it under some warm water once you have thoroughly cleaned it!
Step 7: Dry Your Aroma Tube
Use a paper towel to dry out your aroma tube.
Step 8: Admire Your Handy Work 😉
Sheeeeeesh that bad boy is clean!
Step 9: Use A Q-tip To Clean Oven
Sometimes your AVB will fall down into the oven of your Arizer Solo 3 v2. I use a q-tip or a brush to clean out the inside.
Step 10: Do A Burn Off
Run your Arizer Solo 3 at it’s highest temp for one or two sessions, then wipe it back down with a dry q-tip (after it’s cooled). Once you’ve done that, you’re good to go! Enjoy some clean, tasty sessions! I hope you have enjoyed our Arizer Solo 3 v2 cleaning guide and if you haven’t done so already, check out my review of the Arizer Solo 3 v2!